ALL OF THIS FIRST INFO IS BROARD BAND RELATED:
CTR
Aircell WIreless router-shows up as a WRT56g
192.168.1.1
User: admin
PW: admin
CTR must not provide DHCP
ST4200
Shows up as AircellAXXESS
To look at incoming sat signal strength.
192.168.1.10
User: Administrator
PW: aircell1mb
Also, this setup provide SMS text service to TS Iridium up/down
ATG4000 This should provide DHCP.
This unit provides Gateway at 192.168.1.15
192.168.1.15:8080/maintenance
User: atguser
PW: letmein
The top STATUS LED on front of the ATG:
Must blink green for 6 to 10 min during boot.
Then it must go solid green.
If it stays blinking green , the problem is in the ATG box.
If it goes solid , troubleshoot other parts of the system.
429 1 HS
429 2 LS
lat 110
lon 111
gs 112
alt 076 comes in on port 2 ls
utc 125 comes in on port 1
After new box installed:
429port 1 and 2 were high, Changed port 2 to low
Basic Config:
changed Lat to 110
Changed Lon to 111
Changed gs to 112
Changed alt to 076
left time at 125
THIS IS AFIS/AIRINC/SATDAT/NARROWBAND/WHATEVER RELATED:
the afis connects to the ST4200 STU/DATA port via a DIU under the MED:
192.168.1.25
blank username
pw aircell1 or Aircell1
AGT BM lbt(?) must be set to “2” to look at channel 2
the diu can be wired 232 (all 9 are used) or ethernet 4 wire.
ALL OF THE FOLLOWING INFO IS VOICE RELATED:
IPPBX – this is the voice public exchange configuration area.
Laptop must be set to ?Hard IP? rather than ?DHCP? BE SURE TO SET THE LAPTOP TO A HARD IP THAT IS NOT IN USE< FOR EXAMPLE 192.168.1.217
Brouser to : 192.168.1.200 (IE or Firefox)
User: General User – note Camel Caps, note space in the middle
pw: letmein – all lower case
port 81 – cockpit handset
port 82 – r vip handset
port 83 – conference table handset
Here is is the autolog on shut off proceedure:
Quick Configur efo rthe handsets:
Phone number information:
Satcom Box sn 120231042
ATG 4000 r/t: 1398910438
192.168.1.10
General User
pw
Ken Klien direct line: 303 301 3272
303 301 3272
+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++