toddheffley.com

Search
Skip to content
  • About
  • Avionics
  • F50
  • F900
  • Fairview Airport 40th Anniversary
  • Falcon
  • Family
  • TS
  • Welcome
Avionics

How do you test pin tension on a Collins Proline 2 connector?

November 12, 2015 Todd's Time

The spade must be less that .020 inch thick.

 

 

Post navigation

Previous PostF900 antiskid test normalNext PostWhy is DU4 RED X on F900ex 028?

  • Citation X, left main outflow valve.
  • Lear 40xr hubcap
  • All in 1 avionics tester
  • what is the correct maintenance release for A and P on a part 91 airplane
  • Start-run capacitor on craftsman compressor

Blog to hold some troubleshooting information

login

  • Log in
  • Entries RSS
  • Comments RSS
  • WordPress.org

Recen

  • Citation X, left main outflow valve.
  • Lear 40xr hubcap
  • All in 1 avionics tester
  • what is the correct maintenance release for A and P on a part 91 airplane
  • Start-run capacitor on craftsman compressor

Catagories

  • AircraftTroubleshooting (219)
  • Avionics (34)
  • F20 Troubleshooting (8)
  • F50 Troubleshooting (45)
  • F900 Troubleshooting (99)
  • Falcon (8)
  • Family (45)
  • FARA (5)
  • G200 (4)
  • Honda (4)
  • SermanNotes (11)
  • tECHNOLOGY (48)
  • Uncategorized (319)

Here is the list of:

AircraftTroubleshooting
  • Lear 40xr hubcap
  • All in 1 avionics tester
  • what is the correct maintenance release for A and P on a part 91 airplane
  • Lorawan tempurature
  • 4 pin, .1 inch spacing connector

The current category is:

  • what are typical NEW resistance allowance for switches?
  • How do I put TCAS II in TA on the ground in a Falcon 50?
  • How does a king air fusion combine E.L. and incandescent dimmers?
  • What is the Collins Old Autopilots CD.
  • Why would a APS-80 in a Westwind II give TRIMA and TRIMB fail?
Proudly powered by WordPress
WP-Backgrounds Lite by InoPlugs Web Design and Juwelier Schönmann 1010 Wien