Insert the USB key with the regular Nav Data Base.  The Aircraft Data Base files are on the same disk.

On the “DATA LOAD page, the 2R key should say ‘Aircraft DB”.  … If the stick has the DB on it, and it is plugged in to the data loader correctly.

Choose f900V2 or some such.

Page 6-172 of the pilots guide.

You must load both sides seperatly.

__________________

Some other notes

http://www51.honeywell.com/aero/portal/images/Direct-TO_August2010.pdf

My performance values do not seem to be correct (ceiling altitude splits, cruise alt splits,

ETE’s, Fuel Estimates)

1. Verify that the proper Aircraft Database is in use. You can do this by looking on PERF INIT

page 1, under ACFT TYPE. This should correspond to your specific aircraft.

2. If the ACDB is incorrect (or to clear and reset ACDB performance to the default values) reload

the correct ACDB. The ACDB is available on either floppy disk 1 or 2 or the USB thumb drive

(as appropriate) of your monthly Navigation Database update.

Repeat all Data Load, Tail # and V-Speed Label steps on all CDUs.

3. Verify that SmartPerf Learning is turned

ON

on all FMSs until performance values are as desired.

At that point, turn

OFF

SmartPerf on all FMSs. Leaving SmartPerf

ON

for an extended period can