If you want pluhs, they should be the box mount mate to this plug:
All posts by Todd's Time
How do the aluminum bus feeds splice in a 900b
what are typical NEW resistance allowance for switches?
MIL-DTL-3786: 20 milliohms (Rotary Switches)
MIL-S-6807: 20 milliohms (Snap Pushbuttons)
MIL-S-8805: 40 milliohms (Pushbuttons)
MIL-S-83504: 100 milliohms (DIP Switches)
Anna Heffley-Cline remembers
Falcon 50 Falcon 900 roll control slider bearings
Why take time to remove the upper slat panels during a aileron linkage grease job:
Black mold, and black Vegi-Mite grease.
Half of the linear bearings are difficult to access from the bottom. So they tend to be ignored.
Best to take the time, remove the upper panels and do a though job.
How do I put TCAS II in TA on the ground in a Falcon 50?
Target the gear to get WOW
Disconnect the down brace prox (2 on each) to get GEAR NOT DOWN.
Disconnect RA RECV coax cable to get RA 2500 FT.
observe RA 2500 FT on the ADI
Select FID on TXP
Why do I have SPEED BRAKE FAULT light on the side pedestal in my Falcon 900/ 900EX/ 50 / 50EX with aftermarket winglets?
F50 F900 wingtip light transparancy plastic washers
jewish high holidays
Good introduction to Jewish high holidays
AEGIS software setup for Falcon 900ex and 50ex
Aegis download
PC related.
1. must be an XP laptop as far as I am concerned.
2. On the little Aspire we use, the usb port matters.
3. AEGIS folder is called AE1720.
Aegis related:
281,282 shows?
AE876 NOT FOUND. Check battery, check virtual serial port installed for your particular USB adapter.
Must hear dingdong when USB is plugged in.